Once the engine is started, the chainsaw must be on level ground. Once the saw is stable, the user must engage the chain brake. Place the right foot under the rear handle. The left hand should hold the top handle. The right hand should be used to pull the rope. The Stihl Ms 250 chainsaw should be handled with extreme caution. Even experienced users should follow the instructions in the readers’ manual carefully.
After ensuring that the chainsaw is on level ground, the user should engage the chain brake. To start the chainsaw, place the toe of the right foot under the rear handle. To operate the saw, grasp the front handle using the left hand and the rope with the right hand. Pull the starter rope slowly and quickly. It may be necessary to repeat the process more than once. Using too much force too quickly could flood the engine with fuel.
To start the engine, place the chainsaw on level ground and engage the chain brake. Then, grasp the top handle with the left hand. During this process, pull the starter rope, ensuring that it is positioned in the off position. If the chainsaw does not turn on, pull the starter rope one more time. Make sure that the handle is in the off position or it may flood the engine with fuel.
When starting a Stihl ms 250 chainsaw, it is important to be sure that the trigger is locked. To start the saw, the trigger must be locked and the trigger must be pulled in order to start the engine. Next, the starter rope should be lifted to the start position. If it does not drop, then the throttle has not been locked. Then, the chainsaw should be turned on. After this, the saw should be turned on and the handle should be removed.
Before starting a Stihl ms 250 chainsaw, it is important to ensure that the saw is level. If the saw is on level ground, place the toe of the right foot under the rear handle. Now, grasp the top handle with the left hand. If the chainsaw is in a different position, pull the rope again and engage the brakes.
After engaging the chain brake, you can move the chainsaw between your knees and grip the top handle with your right hand. When you have the rope in place, grab the starter rope with your right hand and pull the rope. Once you feel the cylinder start, pull the rope slowly and firmly. You may need to try several times to get the engine started properly. Then, you can use the rest of the starter rope.
After you have secured the chain brake, you should engage the throttle. To do this, place your right foot under the rear handle and hold the top handle with your left hand. To start the saw, pull the starter rope as far as possible, slow and steady. If the saw drops slowly or jumps a few inches, the ignition system is good and fuel is flowing. If the saw does not drop in increments, turn it off and check the battery for any sparks.
After you have engaged the chain brake, you should set the chainsaw on level ground. Once you have done this, you should engage the chain brake. Now, hold the front handle with your left hand and pull the starter rope. You should then hold the upper handle with your right hand and pull the starter rope slowly and quickly. Remember that you should avoid pulling the rope too hard, as this will flood the engine with fuel.