how to start stihl chainsaw ms170 Chainsaw & Drill Review
sv

how to start stihl chainsaw ms170

how to start stihl chainsaw ms170 To start your Stihl chainsaw, first release the chain brake. Hold the brake handle in your left hand. Then, pull the spark plug out with the recoil starter. Make sure that the spark plug is touching the head of the engine. Press the choke lever until the spark comes out. After this, you should be able to turn on the bar. Before starting, make sure that the chain is lubricated. To do this, hold the saw up against a light-colored surface and open the throttle to see how much lubricant is on the chain.
how to start stihl chainsaw ms170 Chainsaw

How to Start a Stihl Chainsaw MS170

To start your Stihl chainsaw, first, remove the foot from the handle. Next, blip the throttle trigger with your right index finger. Then, turn the master control lever into the “Run” position. Now, lift the chainsaw with your left hand. Once the chain brake has been released, move the front handle to the run position. Do not press the throttle trigger yet. After the chain has been released, you should hear a clicking noise. To avoid injury, hold the front handle to prevent it from slipping off.

To start your Stihl chainsaw, you need to turn on the fuel by using the starter rope. You should see a green flame and the chain will spin slowly. Once the engine is running, you can turn it off. You can use the choke lever to set the speed of the engine. If you are using the cold-start function, you must move the master control lever to the “Run” position. To start the saw on a cold-start, you need to remove the choke by pulling the starter rope.

During the start-up process, you should make sure to put in the gas. You should also check the spark plug. You can use the choke for a cold start by bypassing the choke step and moving the master control to the “Run” position. Once the engine starts, the next step is to push the starter lever to turn on the engine. Then, you should repeat the entire process for a warm or hot start.

The next step is to press the starter rope. You can use the starter rope to push the trigger. The engine should start right away. Once it has started, you should pull the starter rope. Once the engine is hot, you can move the master control lever to the run position. When the chainsaw is cold, you can press the choke lever again to release the gas. It may take several pulls to turn on.

The next step is to turn on the engine. The first step is to start the engine by removing the choke. When the engine is hot, you should make contact between the bar and the surface. You should then turn off the gas and begin cutting. You can now use the Stihl chainsaw Ms170. This tool is very easy to start, but you must follow the instructions in the manual carefully to prevent injury.

Before you use your Stihl chainsaw, make sure it is plugged in. To start the engine, turn off the ignition. Then, turn on the fuel pump. The gas will be hotter if you have a lighter-colored starter. If you use the engine in cold conditions, turn off the fuel pump. You must also fill the gas tank. This step will help you start your saw. Once the engine is running, you should switch off the gasoline. Then, you should slide the choke lever.

To start your chainsaw, unfasten your foot and remove the primer bulb. To start the engine, hold the front handle to prevent injuries. Once the engine has started, you should put the foot on the handle and pull the throttle trigger. To do this, tap the throttle trigger until the engine is in idle. If you’re holding the front handle, you’ll need to lift the chainsaw.

Afterward, move the master control lever to half throttle and turn on the engine. After a few pulls, you should notice that the engine has started. The engine may sputter a little before settling. Then, you should push the trigger again. The bar and chain must not make contact with the surface. After all, you want to make sure that the fuel and throttle are connected to each other.

] }
  • Site İçi Yorumlar

At least 10 characters required